Share The Power

The simpleSwitch is a cost-effective load management device that automatically manages the power to enable the addition of an EV charger or other high power device to a home with a full panel or where the additional load would exceed the load calculations—no need for a panel upgrade or sub-panel. 

The simpleSwitch can share with a single high power appliance (i.e., oven) or share a receptacle in the garage with the whole home allowing high rise/multi-family units to add charging capability to parking spots. (additional purchase of CTs required). 

Our unit allows sharing between 240 to 240, 120 to 120, or 240 to 120. May share between two appliances or can be "daisy-chained" for multiple appliance shares or share between the whole home and a receptacle or single appliance and a receptacle. 

The simpleSwitch is UL approved (UL E510161) as a power management device.

Use this device as a type 2 EVSE Charger*.  Charging capability along with single appliance or whole-home power share with a 25ft cable and J1772 connector. May also be used to power share between EV's.

*UL approval is pending but can be used if no inspection is required. 

  

Technical Specification Sheet

Installation Instructions

Warranty

Questions on what you need? Reach out, and we will make it simple.

Type 2 EVSE changing 32amp charging cable with a standard J1772 connector

simpleSwitch 240M allows the connection of any EV charger or other high-power appliance to a full circuit panel by managing the power available at any given time in a home, apartment, or condo.

simpleSwitch reads the total power consumption of an electrical panel. It then detects when the entire power consumption of the main circuit breaker exceeds 80% and automatically sheds the energy load to the secondary appliance.

When electrical consumption is less than 80% it automatically sends the power back to the secondary appliance or EV charger.  

With this device, you will need specific CTs for your job either clamp style or flex-rope style. 

This model includes the price for the flex-rope style CTs. 

simpleSwitch 240M allows the connection of any EV charger or other high-power appliance to a full circuit panel by managing the power available at any given time in a home, apartment, or condo.

simpleSwitch reads the total power consumption of an electrical panel. It then detects when the entire power consumption of the main circuit breaker exceeds 80% and automatically sheds the energy load to the secondary appliance.

When electrical consumption is less than 80% it automatically sends the power back to the secondary appliance or EV charger.  

With this device, you will need specific CTs for your job either clamp style or flex-rope style. 

This model includes the price for the clamp style CTs.